![]() Be sure to protect all cables and important equipment such as fuel lines, brake lines and the electrical wiring from damage. Confirm that no parts are behind the panel when drilling a hole for installation of the amplifier.To prevent an electric shock or short-circuit during connection and installation, be sure to disconnect the negative (–) terminal of the battery beforehand.Contact the dealer if you cannot detect the cause.In such a case, switch the power to the system OFF and check the connection of the power supply and speakers. To prevent malfunction of the amplifier and speakers, the protective circuit will cut the power supply to the amplifier (sound will stop) when an abnormal condition occurs.Detect the cause and solve the problem, then replace the fuse with another one of the same size and rating. Check the connections of the power supply and speakers if the fuse of the separately sold battery wire or the amplifier fuse blows.For traffic safety and to maintain safe driving conditions, keep the volume low enough so that you can still hear normal traffic sound.Also, do not touch the amplifier when it is wet. Do not touch the amplifier with wet hands.Connect the battery wire directly to the car battery positive terminal (+) and the ground wire to the car body. Always use the special red battery and ground wire, which is sold separately.If you have any questions or concerns, please contact your local authorized Pioneer dealer or call Pioneer customer service. Two 8 Ω speakers in parallel to achieve a 4 Ω load or use a single 4 Ω speaker per channel. For a four-chan- nel amplifier, follow the speaker output connection diagram for bridging as shown on the back of your amplifier, and wire ![]() #Pioner 6100 installTo properly install or use a bridged mode for a two-channel amplifier and achieve a 4 Ω load, wire two 8 Ω speakers in parallel with Left + and Right - (Diagram A) or use a single 4 Ω speaker. The amplifier surface could also become hot to the touch and minor burns could result. Amplifier damage, smoke, and overheating could result from improper bridging. Use of an improper fuse could result in overheating and smoke and could cause damage to the product and injury including burns.ĭo NOT install or use your Pioneer amplifier by wiring speakers rated at 4 Ohm (or lower) in parallel to achieve a 2 Ohm (or lower) bridged mode (Diagram B). Never replace the fuse with one of greater value or rating than the original fuse. When the unit does not operate properly, contact your dealer or the nearest authorized PIONEER Service Station. Before attempting operation, be sure to read this manual. Thank you for purchasing this PIONEER product. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |